Product
Materials
The house, support and foot are manufactured from high-quality extruded aluminium. The lock and handle are made from very durable PE-HD plastic (high-density polyethylene) and the pins through the tubes are stainless steel. These materials ensure that the product is fully corrosion-resistant.
Maintenance
As there is no wind-up mechanism, the LT ALU LEG will, apart from regular cleaning, require no maintenance.
Quick and easy to operate
Uncoupling: lift the semi-trailer using air suspension. Move out the leg by pulling out the LT ALU LEG lock. It will be locked again once it has been fully extended. You can then lower the truck until the legs make contact with the ground. Uncouple the trailer and the truck is ready to roll.
No deformation
In most cases, the air suspension of an uncoupled semi-trailer will run empty after some time. This will cause the semi-trailer to tip backwards a little. The foot on the LT ALU LEG will easily balance out the resulting horizontal load. This will prevent any deformation of the support leg.
Interchangeable
Both the size and position of the assembly holes are the same as for all other support leg types, which permits your current semi-trailer to easily be retrofitted with LT ALU LEGs.
Our Products
Three versions
The LT ALU LEG comes in three versions.
The difference between the three is in the length.
LT 650.700
This aluminium drop leg version is mainly used on walking floor, container – and curtainsider trailers with a regular Coupling height approx. 1150mm. The outside profile is 650mm and the inside profile 700mm. The leg can be retracted by 500mm. Since there is a locking hole at around the 50 mm mark, the LT 650.700 can be mounted on almost any chassis type.
The static load capacity of 25 tons per pair is more than sufficient for almost any transport type and the weight of 18 kg per piece is spectacularly low!
LT 650.880
This particular leg is mainly used on tipper trailers, tank trailers and silo trailers with a coupling height approx. 1350mm. The outside profile is 650mm and the inside profile of 880mm is extra long. The leg can be retracted by 650mm. Since there is a locking hole at around the 50 mm mark, the LT 650.880 can be mounted on almost any chassis type.
The static load capacity of 25 tons per pair is more than sufficient for almost any transporter and the weight of 19,5 kg per piece is spectacularly low!
LT 450.620
This particular leg originally has been designed to install on the back of a trailer. Several leading transport organisations use them for stabilization at a loading-dock. In particular cases where the chassis height is low, this type also perfectly can be used as general support leg. It is sometimes used on standard curtainsider instead of curatonside, but mostly on mega trailers and low bed trailers.
The outside profile is 450mm and the inside profile of 620mm is extra short. The leg can be retracted by 400mm.